Retraction issues. It seems I cannot get retraction to work, - 3D
Por um escritor misterioso
Descrição
Retraction issues. It seems I cannot get retraction to work, no matter what I try, leaving me with the strings & blobs pictured below. I’ve tried different retraction settings (0.5 to 1 mm for ABS on my E3Dv5 hotend) in Slic3r (upgraded to 1.0RC2 now), none of which solve the basic issue that the extruder DOES NOT retract at all. I’ve verified my firmware is configured correctly (Max E feedrate set to 50mm/s), and even verified that I can retract at 1800mm/min in pronterface, but while watching
Retraction Calibration - Lukas Pomykal
Setting retractions correctly
How to Adjust Retraction Distance to Prevent Oozing
nozzle not primed after retraction (I think..)
Retraction Bambu Lab Wiki
🔥 The definitive guide to solving 3D printing problems by Bitfab
Retraction issue at the beginning of a new layer/outer wall : r
Retraction: Just say No to oozing
Retraction settings? - Bambu Lab Software - Bambu Lab Community Forum
Retraction issue at layer change - UltiMaker Cura - UltiMaker
de
por adulto (o preço varia de acordo com o tamanho do grupo)
